SKF TKSA 20 Shaft Laser Alignment Tool Kit

SKF TKSA 20 Shaft Laser Alignment Tool Kit

The TKSA 20 system uses two measuring units both provided with a laser diode and a positioning detector. As the shafts are rotated through 180° any parallel misalignment or angular misalignment causes the two laser lines to deflect from their initial relative position.

The measurements from the two positioning detectors automatically enter the logic circuitry inside the display unit, which calculates the misalignment of the shafts and advises on corrective alignments of the machine feet.

Details of the display unit and the mechanical fixture with measuring unit can be seen on figures 6 and 7.

• Connector for measuring unit on Stationary machine
• Connector for measuring unit on Movable machine
• LCD Display
• ON/OFF button
• Increase (+) button
• Next button
• Decrease (-) button
• Previous button
• Machine dimensions (A,B and C) / Measured values (S and M)
• Rear feet values
• Front feet values
• Indication of parallel coupling value direction
• Indication of angular coupling value direction
• Position (9/12/3 o’clock) of measuring units
• Low battery
• Imperial or metric units

Technical data:

Measuring units

• Housing material: ABS plastic
• Type of laser: Diode laser
• Laser wave length: 670 – 675 nm
• Laser class: 2
• Maximum laser power: 1 mW
• Cable length: 1.6 m (5.2 ft)

Display unit

• Housing material: ABS plastic
• Display type: LCD 35 x 48 mm (1.4 x 1.9 in)
• Battery type: 2 x 1.5V LR14 Alkaline
• Operating time: 20 hours continuous operating
• Auto power off: after 1 hour if no keys are pressed
• Displayed resolution: 0.01 mm (0.1 mil with “inch” setting)

Package Includes:

• Display unit
• 2 measuring units with spirit levels
• 2 mechanical shaft fixtures
• 2 locking chains
• Measuring tape
• Quick start guide
• Certificate of calibration
• Batteries
• Carrying case
• 60-Day warranty

CD ROM, including:

• Instructions for use
• Quick start guide
• Instructional video
• Shaft alignment report